Prolitec AirQ 270 TT Manual page 18

about ten seconds.
6. The five buttons will light in sequence from left to right.
7. Remove the SD card; the display will show the currently loaded firmware version and the pump
will run for one second.
:
8. Press to turn on the power.
9. Be sure that the power is on and the appliance is in Run Program mode prior to closing and
locking the door.
Programming the Appliance from an SD card
1. Copy schedule.txt to a FAT32 formatted SD card.
2. Insert the SD card, with the label side down.
3. Press the reset button, and the five buttons will light in sequence from left to right.
: E
4. The and buttons will light alternately.
:
for one second, and the display will show LOAD for about ten seconds.
5. Press and hold
6. The five buttons will light in sequence from left to right.
7. Remove the SD card; the display will show the currently loaded firmware version and the pump
will run for one second.
:
8. Press to turn on the power.
I
to cycle through the modes to the Run Program mode.
9. Press
L
10. Press to view the start time for the first program.
L
11. Press again to view the stop time for the first program.
E F
12. Press or to view the second and third programs.
13. Be sure the power is on and the appliance is in Run Program mode prior to closing and locking
the door.
Copying programs to an SD card
1. Insert a FAT32 formatted SD card, with the label side down.
2. Press the reset button, and the five buttons will light in sequence
from left to right.
: E
3. The and buttons will light alternately.
AirQ 270 Chapter 5 OPERATING INSTRUCTIONS
5
18