Troubleshooting - Toto WASHLET SW3084T40 Instruction Manual

Troubleshooting

First, try the actions described on pages 42 - 45.
If the problem persists, consult the installer, seller, or
TOTO customer service.
(see contact information on the back cover.)
Please check fi rst
■ Is the breaker on the distribution board turned on?
→ Check whether there is a power outage or the breaker has turned
"OFF".
Is the Power LED lit?
■ Is the "Power ON/OFF" setting "OFF"?
→ Switch it to "ON" with the remote control. (Page 15 Step2- 2)
■ Is the "Power" LED on the
main display fl ashing?
→ The main unit is not mounted
properly. Mount them correctly
again. (Pages 34, 35)
■ While the LED is lit, energy saver
operation, so the toilet seat temperature may be
Is the Energy saver
reduced or the warm water heater and toilet seat
heater may be turned off .
LED lit?
■ Is the "
of the remote controller fl ashing?
Is the remote control
➝ Replace the batteries. (Pages 14, 41)
working?
■ Is the remote control transmitter
or the remote control receiver
blocked?
➝ Remove obstructions, dirt, water
droplets or any other blockages.
42
CAUTION
If a water leak occurs, close
the shutoff valve.
Shutoff valve
<Power>
(Pages 22, 23)
" LED on the back
Remote control
Remote control receiver
transmitter
Rear cleansing, Rear soft cleansing, Front cleansing and Wand
Trouble
The wand
(or cleansing water)
does not come out
The wand extends but
the cleansing water
does not come out /
The cleansing water
pressure is weak
is in
The cleansing water
is cold
The remote
control uses
batteries
to operate.
Stops in the middle
of use
Water comes out
unexpectedly from
the wand
Please check
● Did you sit on the toilet continuously for 2 hours or longer? (If so, operation is
stopped for safety purposes.)
➞Stand up from the seat and then use again.
● The seat switch will not turn on unless you sit on the seat properly.
➞Sit back on the toilet seat.
● Are you using a toilet seat cover, a toilet lid cover or
a seat for infants?
➞Remove any covers.
When using a seat for infants or a soft highchair,
remove after each use.
● Are you pressing "Wand CLEAN" button?
• When you press "Wand CLEAN" button, "EWATER+" comes out from the
vicinity of the wand to clean the wand.
➞To clean the wand with it extended, perform "Wand cleaning".
● Has a water failure occurred?
➞Press "Stopping" button on the remote control and wait until water service
is restored.
● Is the shutoff valve closed?
➞Fully open the shutoff valve.
● Is the water fi lter drain valve clogged with foreign matter?
➞Clean the filter.
● Is the water pressure set to a low level?
● Is the water drain plug loosened?
➞Tighten the water drain plug securely.
● Is the warm water temperature set to "OFF" or a low level?
● When the temperature of the water supply or the bathroom is low, the water
temperature may be low when fi rst sprayed.
● Is the timer energy saver in operation?
• The energy saver feature is on when the "Energy saver" LED is on and the
"Power" LED is off on the main display.
When you sit on the seat, the warm water heater is temporarily turned on
and water is warmed in about 10 minutes.
➞When the timer energy saver is set to "ON", you can also turn it "OFF".
● "Rear cleansing", "Rear soft cleansing" and "Front cleansing" stop
automatically after 5 minutes of continuous use.
● Does the seat switch have diffi culty detecting?
➞Sit back on the toilet seat. If you get up slightly from the seat, or sit forward on
the seat, the seating switch may temporarily stop detecting your presence.
● Water may sometimes come out from around the wand when it expands in
the warm water tank.
● Is the "Wand CLEAN" LED on the main display fl ashing?
➞"Auto Wand CLEAN" starts and the wand is cleaned.
Ref.
Page
-
11
Covers
11
36
-
15
37
18
40
20
-
22, 23
25
-
11
-
16
43