Main Unit; Gap Between The Main Unit And The Toilet Lid - Toto WASHLET SW3084T40 Instruction Manual

Maintenance

Main Unit

Soft cloth
soaked in water
1
Unplug the power plug.
2
Wipe with a soft cloth that has been soaked in water and wrung out
thoroughly.
■ For heavy dirt
• Wipe with a soft cloth soaked in diluted, neutral kitchen detergent, and then wipe with a soft cloth
soaked in water.
Neutral kitchen detergent
3 Insert the power plug.
• The "Power" LED lights up.
Attention!
●This product is an electric appliance. Be careful not to let water seep inside or leave detergent in the gap
between the main unit and bowl unit. (May damage plastic parts or cause a malfunction.)
●When using a toilet cleaner to clean the toilet, rinse it off within 3 minutes and leave the toilet seat and toilet
lid open.
• Wipe off any cleaner that remains on the bowl unit.
(If vapor from a toilet cleaner enters the main unit, it may cause a malfunction.)
●Do not push or pull the covers around the wand with undue force.
(May cause damage or malfunction.)
●Wipe the back surface of the toilet seat and the toilet seat cushions with a soft cloth tightly wrung out with
water.
(Otherwise adhesion of dirt may result in discoloration.)
32
Main Unit
(Approximately daily)
• Toilet paper
• Dry cloth
• Nylon scrubbing brush
(May cause damage)
• Paint thinner
• Benzene
• Powdered cleanser

Gap between the Main Unit and the Toilet Lid

Gap between the Main Unit and the Toilet Lid
The toilet lid can be removed for
thorough cleaning.
1
Unplug the power plug.
2
Remove the toilet lid.
Slightly tilt the toilet lid to the front.
↓
: Pull the left side outward.
↓
: Disconnect the hinge from the recess
and pull up.
↓
: Disconnect the right side.
Wipe with a soft cloth that
3
has been soaked in water
and wrung out thoroughly.
4
Reinstall the toilet lid.
: Join the pin and the hinge on the
right side.
↓
Slightly tilt the toilet lid to the front.
↓
: While pulling out the left side,
↓
: Mount by joining the hinge with the
recess.
* Be careful not to pinch your fi ngers.
5
Insert the power plug.
• The "Power" LED lights up.
6 Open and close the toilet lid
to check the reinstallation.
(Approximately once a month)
Soft cloth soaked Toilet paper, etc.
in water (May cause damage.)
Removing and Reinstalling
Hold with
both hands
Pin
Recess
Hinge
Hinge
33