Long Periods Of Disuse; Removal Of Operation Guide - Toto WASHLET SW3084T40 Instruction Manual

What to Do?
If the toilet is in a location you will not visit for a long time, drain the water.
(Failure to do so may cause breakdown or skin irritation due to polluted product tank water.)
How to drain the water
Drain the water from the toilet tank.
1
1 2
(Page 39 Step )
Extend the wand.
2
(Release the pressure from the water supply pipe.)
(Page 39 Step 3 )
3
Unplug the power plug.
4 Drain the pipe. (Page 39 Step
*After draining the water, Keep the cover
removed.
■ If water may get frozen
• Add antifreeze solution in the water in the bowl to prevent freezing.
(The antifreeze solution should not be fl ushed out. Collect it before using the toilet and dispose of it.)
■ To use the product again
• The water needs to be resupplied. (See below)
Resupplying the Water
1
Open the shutoff valve.
• Check that water is not leaking from a pipe or the main unit.
If the power is not on,
2
Insert the power plug.
• The "Power" LED lights up.
3
Discharge water from the wand.
(1) Pressing down the left side of the toilet seat,
(2) Press "Rear cleansing" button on the remote control to discharge
water from the wand for about 2 minutes.
• It takes about 1 minute maximum before water comes out.
• Catch the water in a paper cup or other receptacle.
(3) Press the "Stopping" button on the remote control.
■ If the remaining water has frozen and no water comes out
• Heat the inside of the bathroom, and warm the water supply hose and shutoff valve using a cloth soaked in warm water.
40

Long Periods of Disuse

Loosen the water drain plug until water
5
comes out from around the wand.
• Water comes out from around the wand.
(It takes about 3 minutes to complete draining.)
* The water drain plug cannot be removed.
Water drain plug
Flat-head
screwdriver
Tighten the water drain plug
6
5
)
securely with a fl at-head screwdriver
and reinstall the cover.
Soft cloth soaked in water
(to prevent scratching)

Removal of Operation Guide

Follow the procedure below.
1
Unplug the power plug.
2
Remove the remote control from the hanger.
(Page 14)
3
Remove the hanger and
operation guide.
4
Screw the hanger on the wall.
5
Mount the remote control in the hanger.
6
Insert the power plug.
• The "Power" LED lights up.
Paper cup
■ To install back the operation guide, follow the procedure above.
(Install the operation guide at step
How to remove the operation guide
Phillips screwdriver
Screw
4 .)
Hanger Operation guide
41