If The Water Does Not Fl Ow Due To A Water Service Interruption; If You Cannot Operate With The Remote Control; Freeze Damage Prevention - Toto WASHLET SW3084T40 Instruction Manual

What to Do?
If the water does not fl ow due to a water service interruption

If you cannot operate with the remote control

If the water does not fl ow due to a water service interruption
1
Use a bucket to fl ush water.
If the water level is low after
2
fl ushing, add more water.
• Prevents odors.
Attention!
• When the water supply is restored, be sure to perform
a fl ush.
(To prevent waste from remaining in the drain pipe.)
If you cannot operate with the remote control
■ If the low battery warning mark "
of the remote control is fl ashing, please replace the
batteries.
■Replacing the batteries
1
Unplug the power plug.
Remove the remote control from the
2
hanger.
(Page 14)
Open the battery cover and replace two
3
AA batteries.
(Page 14)
• The low battery warning mark goes off .
4
Mount the remote control in the hanger.
5
Insert the power plug.
• The "Power" LED lights up.
Attention!
• "ON" and "OFF" settings of the functions such as the energy saver function may be canceled when the batteries
are replaced. Set them again.
38
Large bucket
Pour strongly,
aiming at the center
of the bowl unit.
Newspaper,
dust cloth, etc.
" on the back
It is the time to replace
the batteries.
<Power>

Freeze Damage Prevention

When the ambient temperature is likely to drop to 32 °F (0 °C) or lower, take measures to prevent freezing.
Attention!
• When the ambient temperature is likely to drop to 32 °F (0 °C) or lower, do not use the energy saver feature.
(May damage the product.)
• Warm the bathroom or take measures against freezing so that the ambient temperature does not drop below 32 °F (0 °C).
How to freeze damage prevention
1
Close the shutoff valve.
(Page 36)
• The water supply stops.
CAUTION
Do not remove the water fi lter drain valve
while the shutoff valve is open.
(Otherwise, water may leak out)
Drain the water from the toilet
2
tank.
• Manipulate the lever/button/etc. until the
water stops.
Extend the wand.
3
(Release the pressure from the water supply pipe.)
To operate from the back of remote control
(1) Press "Wand cleaning" button.
(2) Press "Stopping" button on the front
side of the remote control.
• The wand retracts.
To operate from the front of remote control
• Recommended if the remote control is secured to
prevent theft.
(1) Press "Stopping" button until all LEDs
on the remote control start fl ashing. (about
10 seconds)
(2) Press "Front cleansing" button about 3
seconds or longer.
(3) Press "Stopping" button on the front
side of the remote control.
• The wand retracts.
4
Unplug the power plug.
5
Drain the pipe.
(1) Remove the cover and water fi lter drain valve.
• Loosen the water fi lter drain valve with a
fl at-head screwdriver and then pull it.
Water fi lter drain
valve
Cover
Flat-head screwdriver
(2) [Applicable to SW3084 only]
• Drain the water from the water supply hose.
Water supply hose
Horizontally
(3) When water draining is completed, reinstall
the water fi lter drain valve and cover.
• Insert the water fi lter drain valve and use a
fl at-head screwdriver to tighten it securely.
Insert the power plug.
6
• The "Power" LED lights up.
Set the water and toilet seat
7
temperature to "High".
(Page 20)
• To maintain the temperature, close the toilet seat
and toilet lid after fi nishing work.
■ To use the product again
• The water needs to be resupplied. (Page 40)
39