Attaching The Glass Shade - Kendal Lighting AC-21152 Installation Instructions Manual

10. INSTALLATING THE
MOUNTING PLATE
Step 1. Remove 1 of 3 screws from the
mounting ring and loosen the other 2 screws.
(Do not remove)
Step 2. Place the key holes on the mounting
plate over the 2 screws previously loosened
from the mounting ring, turn mounting plate
until it locks in place at the narrow section of
the key holes. Secure by tightening the 2
screws previously loosened and the one
screw previously removed. (Fig. 17)
11. ATTACHING THE 17W
LED ASSEMBLY
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove 1 of 3 screws from the
mounting plate and loosen the other 2 screws
(Do not remove). (Fig 18)
Step 2. While holding the 17W LED assembly
under your fan, firmly snap the wire connection
plugs together.
Step 3. Place key holes on the light kit plate
over the 2 screws previously loosened from
the mounting plate, turn light kit plate until it
locks in place at the narrow setion of the key
holes.Secure by
previously loosened and the one previously
removed. (Fig 18)
12. ATTACHING THE
GLASS SHADE
Install the glass shade by carefully turning
it clockwise until snug. DO NOT OVERTIGHTEN.
(Fig. 19)
tightening 2 screws
Screws
Mounting plate
Connection plugs
17W LED assembly
Mounting
plate
8
Figure 17
Figure 18
Glass shade
Figure 19
Mounting
ring
Mounting
plate
Screw