Table of Contents
Advertisement
Install Handle Assembly
1. Slide handle assembly and shaft collar onto the work arm assembly. Tighten set screws in the shaft collar using a
4mm Allen wrench.
NOTE: Make sure set screws face away from the user when shaft collar is installed.
NOTE: Make sure handle shaft on the handle assembly is aligned between the two bumpers on the work arm
assembly.
2. Install screws and washers securing the counter weight to the work arm assembly using an 8mm Allen wrench.
Item
1
2
3
Tighten hardware to 8-10 ft-lb (10.8-13.5 Nm).
Item
1
2
Item
1
2
3
4
Tighten hardware to 14-16 ft-lb (19-21.7 Nm).
Page 29 of 40
Description
Handle Assembly
Work Arm Assembly
Shaft Collar
Description
Handle Shaft
Bumper
Description
Counter Weight
Work Arm Assembly
Washer, Flat 3/8"
Screw, M10 x 1.5, 25mm
Qty.
1
1
1
Qty.
1
2
Qty.
1
1
2
2
Advertisement
Table of Contents
