Connecting The Outlet Hose; Connecting The Inlet Hose - Hanseatic HGTI4582C10J7710DS User Manual

Installation, fitting, connection and initial commissioning

Connecting the outlet hose

NOTICE
Potential malfunction!
Waste water must be able to run away
freely at all times.
■ Ensure that the waste pipe has a di-
ameter of 40 mm.
■ Ensure that there are no kinks or dam-
age to the outlet hose.
■ Make sure that the end of the hose is
not submerged in the pumped water.
■
Do not extend the outlet hose or re-
place with another drainage pipe.
B
A
Ø 40 mm
The outlet hose (22) can be connected in two
ways:
– Option A:
Connection to a floor drain.
– Option B:
Direct connection to the odour seal (siphon)
of your washing/dishwashing basin.
The outlet hose must be a maximum of
1000 mm above the floor. Technical meas-
ures must be taken for connection. For this
reason, only plumbing experts or members
of our service team may connect the outlet
hose (see page EN-38).

Connecting the inlet hose

NOTICE
Risk of damage!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be able
to run freely into the dishwasher, oth-
erwise this can damage the appliance.
■ For water pressure of less than 10 bar,
install a pressure reducer (in case of
doubt, seek information from the wa-
ter supply company).
■ Do not connect the dishwasher to
the tap or the mixer valve of a water
heater (e.g. continuous fl ow heater,
pressure-free boiler).
■ Ensure that the inlet hose is correctly
connected and is not kinked or dam-
aged.
■ Do not damage the inlet hose; it con-
tains electrical components. If the
inlet hose is damaged, contact our
service department (see „Service" on
page EN-38).
3
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
Page EN-29
¾ inch
Inlet hose with
rubber seal