Error Message In The Display - Hanseatic HGTI4582C10J7710DS User Manual

Page EN-36 Troubleshooting table
Problem Possible cause
The dishwasher salt is
The display (13)
clumpy.
is illuminated, even
though dishwasher
salt has been added.
The water is not run- There is a kink in the inlet
ning or it is running hose.
only very slowly.
The water tap has not been
turned on properly.
The water is not run- The filters are blocked.
ning off or only very
The outlet hose is kinked,
slowly.
has been extended or is
hanging too high up/too low.
The dishwasher is The door seal is defective.
not watertight.
The outlet hose or the inlet
hose is defective.
The dishwasher can The dishwasher can only be
be switched on/off, operated when the door is
but not cannot be closed.
operated.

Error message in the display

Code Solution
: Turn the water tap on completely.
E1
It takes too long for
Lay out the inlet hose in such a manner that it is not kinked.
the water to fill up.
See „Connecting the inlet hose" on page EN-29.
Ensure that the water pressure is correct. See „Technical specifications"
on page EN-40.
: Switch off the tap. Find the gap in the seal (or have someone find it) and
E4
Water overflow repair the leak (or have it repaired).
:
E8
Have the appliance examined and repaired.
Internal fault
:
Ec
Fault in the wash- Have the appliance examined and repaired.
ing control system
Solution
Stir the dishwasher salt using the end of
a spoon or similar.
Lay out the inlet hose in such a manner
that it is not kinked.
Turn the water tap on completely.
Clean the filters (see page EN-26).
Lay out the outlet hose in the proper
manner (see page EN-28).
Have the door seals replaced
(see „Service" on pageEN-38).
Have the defective hose replaced
(see „Service" on pageEN-38).
Close the door.