Installation, Fitting, Connection And Initial Commissioning; Choose A Suitable Location; Connecting The Outlet Hose - Hanseatic WQP8-J7710D User Manual

Installation, fitting, connection and initial commissioning

Installation, fitting, connection and initial commissioning

Choose a suitable location

CAUTION!
Risk of injury!
Improper handling of the appliance
may result in injury.
The appliance is heavy and bulky.
■
Seek the help of another person dur-
ing transport, installation and assem-
bly.
If a trolley is used to move the appli-
■
ance, the appliance must be moved
as shown on the packaging.
Only lift the appliance as shown on
■
the packaging.
Remove all obstacles on the transport
■
route and from the installation loca-
tion, e.g. open doors and clear away
objects lying on the fl oor.
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
Check whether your electricity sup-
■
plier has any regulations about con-
necting dishwashers.
Ensure that the mains plug (28) re-
■
mains easily accessible after the dish-
washer has been set up and installed.
Never use multi-socket adapters, mul-
■
ti-socket strips, travel adapters or the
like.
We recommend using a pulse-sensi-
■
tive residual current device (RCD).
The planned location must fulfil the following
prerequisites:
– Note that the installation location must be
able to support a total weight of 35.5 kg.
– The location must be a dry and frost-safe
room with a firm ground.
– The dishwasher must be positioned be-
neath a full work surface which is joined
together with the cupboards adjacent to the
dishwasher.
– In order to install the connection pipes, the
dishwasher must be positioned near to a
washing/dishwashing basin.
– The measurements of the recess must at
least correspond to the details in the follow-
ing diagram.
90°
820 mm
580 mm
450mm

Connecting the outlet hose

NOTICE
Potential malfunction!
Waste water must be able to run away
freely at all times.
Ensure that the waste pipe has a di-
■
ameter of 40 mm.
Ensure that there are no kinks or dam-
■
age to the outlet hose.
Make sure that the end of the hose is
■
not submerged in the pumped water.
Do not extend the outlet hose or re-
■
place with another drainage pipe.
Page EN-23
90°
80 mm
100 mm