Device Configuration; Install Protocol Elicence; Hardware Interface Between Mic Ip 7000 Hd And Videojet Decoder 3000 - Bosch MIC Series Tech Note

Confi guration of MIC IP 7000 HD – VIDEOJET decoder 3000 – for integration with analog CCTV | 9/18
4. Device Confi guration
4.1 Install protocol eLicense
Using web browser or Bosch Confi guration Manager, follow instructions in camera operating manual to
install and activate the eLicense needed to support serial protocol functionality.
4.2

Hardware interface between MIC IP 7000 HD and VIDEOJET decoder 3000

The only interface necessary between a MIC IP 7000 HD and a VIDEOJET decoder 3000 is network
connectivity for video decoding. The video can be streamed to the decoder either through a direct
connection or using a network switch. When used with a switch, the decoder gives the fl exibility of
streaming the video and telemetry signal to central control room and decoding the video and telemetry
in the control room rather than in the fi eld.
Note: When using a direct connection, the cable length between the MIC IP camera and the decoder
cannot be more than 100 m (330 ft.) when using UTP cabling.
The fi gure below shows the interface ports for the VIDEOJET decoder 3000 and MIC IP 7000 HD.
Figure 5: VIDEOJET decoder 3000 interface ports.
Bosch Security Systems Version 1.3 | September 2015