Operation Using Embedded Web Server; Accessing Embedded Web Server - Xerox VersaLink B7025 Security Function Supplementary Manual

Operation Using Embedded
Web Server
This section describes the operation using Embedded Web Server to use security features for
System Administrators and authenticated users.
The Embedded Web Server program uses the embedded Web User Interface which enables
communication between a networked computer and the machine via HTTP. Embedded Web Server
can be used to create/edit User accounts, to check each job and the machine status, or to change the
network settings.
NOTE :
For information of the Embedded Web Server feature, refer to the User Guide. Some of the
Embedded Web Server features have restricted access. Contact a System Administrator for further
assistance.

Accessing Embedded Web Server

Follow the steps below to access Embedded Web Server . On a client computer on the network,
launch an internet browser.
In the URL field, enter "http://" followed by the IP address or the Internet address of the machine.
Then, press the <Enter> key on the keyboard.
For example, if the Internet address (URL) is vvv.xxx.yyy.zzz, enter it in the URL field as shown below:
 http://vvv.xxx.yyy.zzz
The IP address can be entered in either IPv4 or IPv6 format. Enclose the IPv6 address in square
brackets.

IPv4: http://xxx.xxx.xxx.xxx
 IPv6: http://xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
If a port number is set, append it to the IP address or the Internet address as follows. In the
following example, the port number is 80.

URL: http://vvv.xxx.yyy.zzz:80

IPv4: http://xxx.xxx.xxx.xxx:80
 IPv6: http://xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:80
The home page of Embedded Web Server is displayed.
Xerox ® VersaLink ® B7025/B7030/B7035 Multifunction Printer
Security Function Supplementary Guide
34