Dell Precision 330 User Manual page 89

bay is engaged. Replace the screw holding the drive bracket to the
drive bay.
I n s t a l l i n g t h e H a r d - D r i v e B r a c k e t ( D e s k t o p C h a s s i s )
Connect the interface cable for the drive. See
8
Cables (Desktop Chassis)."
NOTICE: To avoid possible damage, you must match the colored strip on the
interface cable with pin 1 on both the drive and system board connectors.
If you are installing an EIDE device, ensure that the IDE interface
a
cable is properly connected to the EIDE connector on the system
board. For more information, see
Guidelines."
If you are installing a SCSI device, ensure that the SCSI interface
b
cable is properly connected to the interface connector on the SCSI
controller board. For more information, see
Installation Guidelines."
screw
latch
"Attaching Hard-Drive
"EIDE Device Installation
"SCSI Device
hooks (3)
hard-drive bracket
In s ta l l i n g U p gr a d e s
89