Table of Contents
Advertisement
UG-1820
EVAL-AD4115SDZ QUICK START GUIDE
RECOMMENDED QUICK START GUIDE
Use the following procedure to set up the EVAL-AD4115SDZ:
1.
Disconnect the
SDP (SDP-B
USB port of the PC. Install the
See the Installing the AD411x Eval+ Software section.
Restart the PC after installation.
2.
Connect the
SDP
board to the EVAL-AD4115SDZ. Fasten
these two boards together with the enclosed plastic screw
washer set.
3.
Fasten the EVAL-AD4115SDZ and the
with the enclosed plastic screw washer set.
4.
Connect the
SDP
board to the PC via the USB cable. For
Windows® XP, it may be necessary to search for the
drivers. Choose to automatically search for the drivers for
the
SDP
board if prompted by the operating system.
or SDP-K1) board from the
AD411x Eval+
software.
SDP
board together
SDP
Rev. 0 | Page 4 of 24
EVAL-AD4115SDZ
5.
Launch the
AD411x Eval+
Devices subfolder in the Programs menu.
QUICK START MEASUREMENT
Use the following procedure to capture data quickly:
1.
Connect the dc signal source to a selected voltage input (for
example, the VIN0 pin and VIN1 pin for differential input).
2.
Launch the
AD411x Eval+
(see Figure 15).
3.
In the Configuration tab, under Demo Modes, click All
Single-Ended and then click Sample (see Figure 16).
4.
In the Voltage Waveform tab, the user can evaluate the
measured data.
The Samples box in the top right corner of the
window sets the number of samples collected in each batch.
User Guide
software from the Analog
software and select Quickstart
AD411x Eval+
Advertisement
Table of Contents
Need help?
Do you have a question about the EVAL-AD4115SDZ and is the answer not in the manual?
Questions and answers