Fingerprint-Reader Board; Removing The Fingerprint-Reader Board - Dell Inspiron 3505 Service Manual

Steps
1. Using the alignment posts, place the power-button into its slot on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure the power-button to the palm-rest and keyboard assembly.
3. Connect the power-button cable to the fingerprint-reader board and close the latch, if applicable.
NOTE: This step is only applicable if your computer was shipped with the optional fingerprint reader.
4. Adhere the Mylar that secures and grounds the power-button cable to the palm-rest and keyboard assembly, if applicable.
NOTE: This step is only applicable if your computer was shipped with the optional fingerprint reader.
Next steps
1. Install the I/O board.
2. Install the base cover.
3. Follow the procedure in

Fingerprint-reader board

Removing the fingerprint-reader board

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
About this task
NOTE: The fingeprint-reader board is an optional component and will only be installed in systems shipped with a fingerprint
reader.
40 Removing and installing components
After working inside your
Before working inside your
computer.
computer.