Steps
1. Place the display panel and display assembly on a clean and flat surface.
2. Connect the display cable to the connector on the diplay panel and close the latch.
3. Adhere the tape that secures the display-cable connector latch to the display panel.
4. Lift and rotate the display panel, then place the display panel on the display assembly.
5. Align the screw holes on the display panel to the screw holes on the display assembly.
6. Replace the six screws (M2.5x2.5) that secure the display panel to the display assembly.
7. Replace the two screws (M2x2.5) that secure the display panel to the display assembly.
Next steps
1. Install the
display
assembly.
2. Install the
wireless
card.
3. Install the
base
cover.
4. Follow the procedure in
Camera
Removing the camera
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
wireless
card.
4. Remove the
display
assembly.
5. Remove the
display
bezel.
6. Remove the
display
panel.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
51