Intended Use; Safety Instructions - FLORABEST BT-7120 Assembly Instructions Manual

Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following assembly
instructions and the safety infor-
mation carefully.
Use the product only as described and only
for the given areas of application. Store these
assembly instructions carefully. When passing
the product on to third parties, please also hand
over all accompanying documents.
Scope of delivery (fig. A)
2 x frame section (1)
2 x frame section (2)
2 x frame section (3)
1 x cross bar (4)
3 x shelf (5)
3 x decorative moulding (6)
18 x screw (7) size 6 x 25 mm
2 x screw (8) size 6 x 30 mm
9 x screw (9) size 6 x 7-8 mm
1 x screw (10) size 6 x 40 mm
1 x nut for screw (11)
1 x ring spanner (12)
1 x spanner (13)
1 x assembly instructions
Technical data
Dimensions: approx. 70 x 60 x 60 cm
(w x h x d)
Maximum load (per shelf):
25
25 kg
Date of manufacture (month/year):
11/2019

Intended use

This product is used to arrange e.g. flowerpots
and decorations. The product is intended for
private use indoors and outdoors.
8 GB/IE/NI

Safety instructions

Important! Read these assembly instruc-
tions carefully and be sure to keep them
handy!
Danger to life!
• Never leave children unsupervised with the
packaging material. Risk of suffocation.
Risk of injury!
• Before using the product check for correct
stability.
• Position the product on an even surface.
• The product may only be used under adult
supervision and not as a toy.
• The product is not for climbing on or playing
with! Make sure that people, especially chil-
dren, do not pull themselves up on the product
or lean against it. The product may tip over.
• Check the product for damage and wear be-
fore each use. Check regularly that all screw
connections are tight!
Assembly
1. Screw together, not too tightly at first, the sec-
tions (1), (2), and (3) using the screws (7), and
the cross bar (4) using the screws (8) (fig. B).
Important: The holes for the shelves of
the stand must face upwards!
2. Screw on the three decorative mouldings (6)
underneath the three shelves (5) using the
screws (9) (fig. C).
3. Place the shelves (5) on the product and
screw them on using the screws (7) (figs. D-F).
4. Tighten all screws firmly.
5. Stand the product upright on the ground (fig. H).
Connecting two flowerpot
stands (fig. G)
1. Remove the plastic pots (1a)/(3a) from the
sections (1)/(3) that you wish to connect.
2. Connect the frame sections with the screw
(10) and nut (11) supplied with the product.