Ultrastar Data102 Packaging Overview - Western Digital Ultrastar Data102 Installation Manual

Installation Guide
4.1 Ultrastar Data102 Packaging Overview
Figure 6: Packaging Layout
The Ultrastar Data102 packaging consists of three layers of packaging: The accessory tray is on top, the
enclosure chassis box is in the middle, and the drive assemblies are on the bottom. The accessory tray
contains three cartons, two for the CMA assembly and one for the rails, as well as plastic bags that contain
all necessary hardware listed below in the tables and the included cables. The chassis is boxed in the
middle and protected by foam padding. It has the rear fans, PSUs, IOM fan, and IOMs pre-installed. On the
bottom there are seven containers that hold fourteen drive assemblies and one container that holds four.
These three layers of packaging are contained by cardboard caps on the top and bottom, and an outer
sleeve that surrounds the sides. Plastic banding surround the packaging and pallet to keep them contained.
Table 14: Box Contents
CMA Box
Accessory Tray
Container

4.1 Ultrastar Data102 Packaging Overview

Contents
2 CMA arms, 1 upper and 1 lower
CMA cross-bar
• 2 Top Cover Guide Brackets
• 2 Rack Latch brackets (One Left, One Right)
• Screws & Nuts
◦ 10 M5 Cagenuts
4. Packaging
32