Table of Contents
Advertisement
Installing the palmrest
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palmrest and provides a visual representation of the installation procedure.
Steps
Place the palmrest on a clean and flat surface.
Next steps
1. Install the keyboard.
2. Install the touchpad.
3. Install the speakers.
4. Install the
system
board.
NOTE:
The system board can be removed or installed together with the heat sink attached.
5. Install the
G key
6. Install the
I/O
board.
7. Install the
light
bar.
8. Install the
power button with optional fingerprint
9. Install the
power-adapter
10. Install the
graphics-card
11. Install the
processor
fan.
12. Install the
M.2 2280 solid-state drive
13. Install the
wireless
card.
14. Install the
display
assembly.
15. Install the
rear-cover
bracket.
16. Install the
rear
cover.
17. Install the
coin-cell
battery.
18. Install the battery.
19. Install the
base
cover.
66
Removing and installing components
reader.
port.
fan.
or
M.2 2230 solid-state
drive.
Advertisement
Table of Contents
