2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
rear
cover.
5. Remove the
rear-cover
6. Remove the
wireless
card.
7. Remove the
M.2 2280 solid-state drive
8. Remove the
memory
modules.
9. Remove the
processor
10. Remove the
graphics-card
11. Remove the
system
board.
NOTE:
The system board can be removed and installed along with the heat sink. This simplifies the removal and
installation procedure and prevents damage to the thermal bond between the system board and heat sink.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the removal procedure.
Steps
1. Remove the five screws (M2x2.5) that secure the touchpad bracket to the palm-rest and keyboard assembly.
2. Lift the touchpad bracket off the palm-rest and keyboard assembly.
3. Open the latch and disconnect the touchpad cable from the system board.
4. Open the latch and disconnect the touchpad cable from the touchpad.
5. Remove the two screws (M2x2) that secure the touchpad to the palm-rest and keyboard assembly.
6. Slide and lift the touchpad at an angle, off the palm-rest and keyboard assembly.
Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.
bracket.
or
M.2 2230 solid-state
fan.
fan.
drive.
Removing and installing components
59