Table of Contents
Advertisement
1.
Launch MAX on the host computer.
2.
Expand Remote Systems in the configuration tree and locate your system.
3.
Select your target.
Tip
number, such as NI-CRIO-9066-1856AAA.
Setting a System Password
Complete the following steps to set a system password.
Note
The default username for the cRIO-9066 is
password for the cRIO-9066, so you must leave the password field blank when
logging in until you set a system password.
1.
Right-click your system and select Web Configuration.
The NI Web-Based Configuration and Monitoring utility opens in your default browser
and is where you set the password. If you have not installed Microsoft Silverlight,
NI Web-based Configuration & Monitoring prompts you to do so.
2.
Enter a unique name for your system in the Hostname field.
3.
Click the Security Configuration icon.
4.
Click Login.
5.
In the Login dialog box, enter the username
6.
Click OK.
7.
Click Change Password.
8.
Enter and re-enter a new password.
9.
Click OK.
10. Click Save.
11. Click OK to confirm you are changing the password.
Caution
you must contact NI and reformat the controller.
Installing Software on the cRIO-9066
Complete the following steps to install software on the cRIO-9066.
1.
In MAX, expand your system under Remote Systems.
2.
Right-click Software.
3.
Select Add/Remove Software to launch the LabVIEW Real-Time Software Wizard.
Tip
4.
Select the recommended software set for your LabVIEW and NI-RIO Device Drivers
versions.
5.
Click Next.
MAX lists the system under the model number followed by the serial
NI cannot recover lost system passwords. If you forget the password,
You must log in if you set a system password.
admin
and leave the password field blank.
admin
NI cRIO-9066 Getting Started Guide | © National Instruments | 9
. There is no default
Advertisement
Table of Contents
