Installing C Series Modules; Removing C Series Modules - NI cRIO-9066 Getting Started Manual

3. LabVIEW FPGA Module 2014 or later
4. NI-RIO Device Drivers 15.0 or later
For minimum software support information, visit
.
swsupport

Installing C Series Modules

Complete the following steps to install a C Series module.
1. Verify that power is not connected to the I/O connector(s) on the C Series module. If the
system is in a nonhazardous location, the cRIO-9066 can be powered on when you install
modules.
2. Press the latches on the C Series module.
3. Align the C Series module with a slot and seat it in the slot until the latches lock in place.

Removing C Series Modules

Verify that power is not connected to the I/O connector(s) on the C Series module before you
remove a module from the cRIO-9066. If the system is in a nonhazardous location, the
cRIO-9066 can be powered on when you remove modules.
Connecting the cRIO-9066
The cRIO-9066 has the following connectors, LEDs, and buttons.
1
LabVIEW FPGA Module is not required when using Scan Interface mode. To program the user-
accessible FPGA on the cRIO-9066, LabVIEW FPGA Module is required.
1
ni.com/info
3
NI cRIO-9066 Getting Started Guide | © National Instruments | 5
and enter the Info Code
2
1
2