System Log; System; Ap Mode - Zcom SP230 Series User Manual

SP230/SP230-S5
Parameter
IPv6 Address
IPv6 Prefix
Default Gateway
IPv6 Primary/Secondary DNS Server
Switch mod
Wireless Switch Address 1/2/3/4
Wireless Switch IPv6 Address1/2/3/4
Wireless Switch Name1/2/3/4
Management VLAN ID

4.2.2.3. System Log

This page is used to display the system log on the AP. Information on this page is useful for
troubleshooting.
4.2.3.

System

4.2.3.1. AP Mode

This page is used to displayed and changed AP modes.
• Thin AP - Specifies to use and configure this AP with a wireless controller in the network. The
wireless controller will be responsible for the configuration of this AP. Only a few functions
are available to be configured on this AP in this mode.
• Fat AP - Specifies to use and configure this AP without a wireless controller in the network.
More functions are available to be configured on this AP in this mode.
2x2 PtP/PtMP 802.11ac Wave 2 Outdoor Access Point
Description
Enter the IPv6 address.
Enter the IPv6 prefix IP address.
Enter the IPv6 address of the gateway for the interface.
Enter primary/secondary DNS server. (if require the second
one)
Displays basic information of the switch mod:
Connect with via DHCP – connect the AP via DHCP of the
network or provided by the Access controller DHCP IP
address.
IP – Connect the AP via Access controller IP address.
DNS - Displays the MAC address of the interface.
Enter wireless access controller IPv4 IP address.
Enter wireless access controller IPv6 IP address.
Enter access controller DNS value.
Enter specific management VLAN ID which is providing
from the Network.
User Manual
Page 14