Zcom SP230 Series User Manual page 23

SP230/SP230-S5
The following parameters are available in this section:
Parameter Description
Displays basic status information of the interface.
Status
After clicking the Switch protocol button, the following will appear:
4.3.3.1.1.1. General Setup
2x2 PtP/PtMP 802.11ac Wave 2 Outdoor Access Point
• Port - Displays the interface name. For example, "eth0.2".
• Uptime - Displays the how long the interface is active.
• MAC Address - Displays the MAC address of the interface.
• RX - Displays the RX (receiving) data rate through the interface.
• TX - Displays the TX (transmitting) data rate through the interface.
User Manual
Page 23