System Log; System; Ap Mode; Reboot - Zcom AS420 User Manual

AS420
Parameter
Wireless Switch Address 1/2/3/4
Wireless Switch IPv6 Address1/2/3/4
Wireless Switch Name1/2/3/4
Management VLAN ID

4.2.2.3. System Log

This page is used to display the system log on the AP. Information on this page is useful for
troubleshooting.
4.2.3.

System

4.2.3.1. AP Mode

This page is used to displayed and changed AP modes.
• Thin AP - Specifies to use and configure this AP with a wireless controller in the network. The
wireless controller will be responsible for the configuration of this AP. Only a few functions
are available to be configured on this AP in this mode.
• Fat AP - Specifies to use and configure this AP without a wireless controller in the network.
More functions are available to be configured on this AP in this mode.

4.2.3.2. Reboot

Click the Perform reboot link to reboot the device any unsaved configuration.
4.3. Fat AP Mode
A FAT AP is suitable for family and small-scaled networks and provides full features. This Fat AP
is wireless equipment used to control and manage wireless clients. A FAT AP may support both
2.4GHz and 5GHz band in a single logic management domain. This Fat AP is used for wireless
terminals to access a wired network; also it can communicate the bridge between the wireless
clients and wired network. Before configuring the fat AP make sure that AP is in fat AP mode. If the
AP is in Thin AP mode, please change into Fat AP mode and precede the following essential
configuration.
4x4 Dual Band 802.11ac Wave 2 Indoor Access Point
Description
Enter wireless access controller IPv4 IP address.
Enter wireless access controller IPv6 IP address.
Enter access controller DNS value.
Enter specific management VLAN ID which is providing
from the Network.
User Manual
Page 12