Installing The Console; Powering The Console; Installing The Ac Power Adapter - DAVIS Vantage Pro2 Console Manual

Chapter 2

Installing the Console

The Vantage Pro2 console is designed to give extremely accurate readings. As
with any precision instrument, use care in its assembly and handling.
Although installing the console is relatively simple, following the steps out-
lined in this chapter and assembling the Vantage Pro2 correctly from the start
will help ensure that you enjoy all of its features with a minimum of time and
effort.

Powering the Console

Cabled Vantage Pro2 Stations
Cabled Vantage Pro2 consoles supply power to the Integrated Sensor Suite
(ISS) through the console cable. Because of the added power consumption of
the ISS, the cabled console requires an AC power adapter or optional Car/
Boat/RV Lighter Cord for the main power supply. The console batteries pro-
vide backup power for up to four to six weeks.
Wireless Vantage Pro2 Stations
Wireless Vantage Pro2 consoles do not require the use of an AC adapter. You
may use the included adapter if you wish, but the three C-cell batteries should
power a wireless console for up to nine months.
Note: When using an AC Power adapter, be sure to use the power adapter supplied with
your Vantage Pro2 Console. Your console may be damaged by connecting the
wrong power adapter. The console does not recharge the batteries. Because of this,
and because NiCad batteries do not power the console as long as alkaline batteries,
use alkaline batteries in the console.

Installing the AC Power Adapter

1. Remove the battery cover located on the back of the console by pressing
down on the two latches at the top of the cover.
2. Find the power jack located on the bottom of the console case.
Power Plug
Wrap Cord Around Pins
4