DAVIS Vantage Pro2 Console Manual page 17

1. Press the up and down arrows to cycle through time zones.
2. If your time zone is not shown, press 2ND then press the up and down
arrows to set your UTC offset.
3. Press DONE to select the time zone or UTC offset shown on the screen and
move to the next screen.
Screen 8: Daylight Savings Settings
In most of North America, including Mexico (excepting Saskatchewan, Ari-
zona, Hawaii, and the Mexican State of Sonora), as well as in Australia
(excepting Western Australia, Northern Territory, and Queensland) and in
Europe use the AUTO Daylight Savings setting. The console is pre-pro-
grammed to use the correct starting and stopping dates for Daylight Savings
Time in these areas, based on the time zone setting in screen 7.
Weather stations located outside of North America, Europe, and Australia or in
areas that do not observe daylight savings time should use the MANUAL set-
ting.
1. Press the up and down arrows to choose Auto or Manual.
2. Press DONE to move to the next screen.
Screen 9: Daylight Savings Status
Use this screen to either verify the correct automatic Daylight Savings status
or to set Daylight Savings manually.Screen 9: Daylight Savings Status
1. Press the up and down arrows to turn Daylight Savings Time on or off on
the appropriate days of the year, if Day Savings setting is MANUAL.
If you have an AUTO Daylight Savings setting, the console display the
appropriate setting based on the current time and date.
2. Press DONE to move to the next screen.
Screen 8: Daylight Savings Settings
Setup Mode
14