Cleaning; Disposal; Trouble Shooting - Holzmann D 460FXL User Manual

15.3

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
15.4

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
16

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine does not start
Strong vibration
Bad turning result
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
HOLZMANN MASCHINEN GmbH
Possible cause
 Switch defective
 Power supply is off
 Fuse is defective
 Circuit breaker is active
 Warped workpiece
 Workpiece is wrong centered
 Loosen pulley
 Outworn pulley
 Turning lathe is on uneven surface
 Loosen tail- or headstock
 Too much speed
 bad sharpened chisel
 Wrong chisel for this work
 Wrong adjustment of tool rest
www.holzmann-maschinen.at
NOTICE
Solution
 Repair switch
 Repair power supply
 Change fuse
 Push in the circuit button
 Change material
 Measure the center newly
 Tighten the pulley
 Change pulley
 Level the surface
 Tighten
 Adjust speed
 Sharpen the chisel
 Select the right chisel
 Adjust the high and the
NOTICE
TROUBLE SHOOTING
distance of the tool rest
D 460FXL
34