Assembly
*NOTE: If you purchased the 'Desktop Power Bar' add-on, skip this
Step 14
step and refer to the 'Add-on: Power Supply' instruction sheet.
a.
Insert three (3) 1/4-20 Phillips Bolts
into the threaded inserts shown (fig.A)
and hand tighten about halfway.
(DO NOT tighten all the way yet)
fig. B
c.
Tighten both bolts ensuring the tray is secured.
Ensure your tray is placed correctly (fig.c)
before tightening the bolts.
14105 Avalon Boulevard, Los Angeles, CA 90061
x3
1/4-20 Phillips Bolt
b.
Pass the bolts through the widest portion of the
outter keyholes on the cable management tray by
lowering the tray onto the underside of the desktop.
Slide tray all the way in so bolts are over narrower
part of keyhole and back of the tray is flush against
back of the desktop. Use the lateral slots to adjust,
if necessary.
|
Tel 310-353-7100
www.VersaTables.com
fig. A
fig. C
|
Fax 310-353-7109