Advertisement
Use
IMPORTANT: You must RESET the desk prior to use.
!
Make sure no obstacles are in the desk's path and the desktop is away from walls.
Make sure all cables are the appropriate length to accomodate the change in height.
Reset Procedure: Press and hold DOWN button on controller until desk reaches its lowest height.
Release DOWN button. Press and hold DOWN button again until LED displays "ASR". Release
DOWN button. Press and hold DOWN button again until desk slightly lowers, rises and stops.
Release DOWN button.Your desk is now ready to use!
Adjusting Desk Height: The desk base can be adjusted by pressing and holding either the UP or
DOWN button until the desired height is reached.
Creating Height Presets: The desk's controller is programmable for up to four presets. To create a
preset, use the UP and DOWN buttons to find a desired height, then
press the 'S' button followed by Preset buttons 1 through 4.
CAUTION: Once a preset button is pushed, the desk will move to the programmed height.
Trouble Shooting
If your desk is not functioning properly it may need to be reset. Unplug the power cord for 20
seconds. Plug the power cord back in and follow the RESET procedure outlined above.
If your desk's contoller LED readout displays an error code "Er1 - Er13" or "ASR", confirm that all
wired connections are secure, then perform the reset procedure above.
If the error message persists after the reset procedure contact Versa Tables.
If the height difference between the legs exceeds 1.5 inches, stop the reset procedure and contact
Versa Tables immediatly.
If the controller displays "HOT", allow the components to cool down for 20 minutes.
14105 Avalon Boulevard, Los Angeles, CA 90061
|
Tel 310-353-7100
www.VersaTables.com
|
Fax 310-353-7109
Advertisement
