Advertisement
Assembly
Step 4
Attach end frame with L-bracket (A) to end frame
with threaded-inserts (B) using (4) M6x10
machine screws.
NOTE:
Do NOT tighten all the way.
Step 5
Slide the two center rails into the two end frames ensuring:
a) Center rail slots face inward
b) Center rail slots are closer to the top edge
b) Center rail slots are closer to the top edge
when the assembly is upside down
(as shown in inset)
Step 6
Place desktop with pre-drilled holes and
pre-installed inserts facing up. (We
reccomend placing them on cardboard,
blanket, rug, etc. to protect surface)
Adjust the width of the desk base by
sliding the two end frames outward.
Align the holes on the desk base and the
underside of the desktop.
Attach the desk base to desktop with
twelve (12) 1/4-20 Phillips Bolts for the
side bracket holes going into the inserts.
Use five (5) M5x20 Wood Screws for the
end frame holes going into the desktop.
14105 Avalon Boulevard, Los Angeles, CA 90061
A
end frames ensuring:
ensuring:
x12
1/4-20 Phillips Bolt
|
Tel 310-353-7100
www.VersaTables.com
x4
M6x10 Machine screw
B
x5
M5x20 Wood Screw
|
Fax 310-353-7109
Advertisement
