Advertisement
Assembly
Step 1
Slide control box (D) off the frame. Fully separate end frames
(A+C), you will find the center rails (B) inside.
NOTE:
End frame C is placed on the side of the desk you plan to mount the control box and controller.
We recommend using the right side.
Step 2
M6x10 Machine screw
Step 3
M6x14 Machine screw
14105 Avalon Boulevard, Los Angeles, CA 90061
A
Place leg into one of the end frames ensuring brackets
are towards the top.
Align holes on leg with holes on end frame and insert
four (4) M6x10 machine screws through the holes in
the end frame and into the leg. Using the supplied
Allen wrench, rotate each screw just a few times.
After all four screws are inserted, tighten all.
x4
Repeat this step for the other two pairs of leg and frame.
Slide the side bracket into the end frame.
Insert two (2) M6x14 Machine screws through the
hole on the bottom of the end frame and into the side
bracket. Using the supplied Allen wrench, rotate
each screw just a few times.
x2
After both screws are inserted, tighten both.
Repeat this step for the other two leg/frame assembly.
www.VersaTables.com
B
|
|
Tel 310-353-7100
Fax 310-353-7109
C
D
Advertisement
