Jaws - Baileigh Industrial MSS-14F Operator's Manual

Here you will see both top and bottom
mechanisms installed for stretching. Both show
the "U" pointing at each other
Also notice that the screw heads (A) point away
from the material gap (B).
Here is a completed setup for stretching.

JAWS

• The jaw block assemblies should be lightly
lubricated so that they will slide freely and evenly.
Use a 40 weight motor oil or similar.
• Clean the blocks regularly to prevent them from
collecting dirt and becoming sticky.
• The pads should be kept clean and dry. If the
pads become oily or grease the will slip on the
material. Use a mild solvent to remove any oil or
grease.
• Use the Square pads for Stretching.
• Use the Serrated pads for Shrinking.
A
U
B
U
A
16
16