Table of Contents
Advertisement
Fleck 2510-XST Sediment Installation & Startup Guide
Assembly and Installation Instructions
1. Unscrew by hand the entire Fleck 2510-XST control valve from top of tank if it was shipped screwed
on. Place distributor tube in tank if not already inside tank. If not already done, make sure blue cap is
on top of distributor tube, or wrap the top of distributor tube with electrical or duct tape. You do not
want Sediment to go down the distributor tube.
2. Next add Sediment filter media (Chemsorb). The tank will be about 2/3rds full of media.
3. Remove cap or tape from top of distributor tube. Be careful not to pull up distributor tube when
removing cap or tape.
4. If possible at this point, fill tank completely with water. This will allow the Sediment Filter media to
settle and eliminate the need of "purging" the air out of the tank later.
5. Screw on Fleck 2510-XST control valve carefully. Do not use pipe-joint compound, Teflon tape, or
Vaseline or other petroleum greases to lubricate tank threads.
6. Lubricate the by-pass valve o-rings with some vegetable oil or silicone grease and connect the bypass
assembly to the Fleck 2510-XST control by sliding the bypass valve firmly into the body of the Fleck
2510-XST. Secure each side with metal adapter coupling and screw.
7. Now install your water pipes to the Fleck 2510-XST bypass end connectors. Make sure inlet is
installed to the 'In" pipe connector on the bypass valve and outlet is on the "Out" connector. Note:
Arrows on bypass valve should be visible from the top of the bypass valve.
Page 8
www.cleanwaterstore.com
Rev 120215
Advertisement
Table of Contents
