Technical Specification - SolidRF BuildingForce 4G-X Manual

Cell phone booster

Hide thumbs

Table of Contents

WARNING:

• The outside antenna must be installed no higher than 10 meters (32'9") above ground.

This is a CONSUMER device.

BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's

consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent

to the use of this device on their network. If you are unsure, contact your provider.

You MUST operate this device with approved antennas and cables as specified by the manufacturer.

Antennas MUST be installed at least 20 cm (8 inches) from any person.

You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service

provider.

WARNING. E911 location information may not be provided or may be inaccurate for calls served by

using this device.

This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation. Changes or modifications not expressly approved by SolidRF could void the authority to operate

this equipment.

RF Exposure: The manufacturer's rated output power of this equipment is for signal carrier operation. For situations

when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the output

is reradiated and can cause interference to adjacent band users. This power reduction is to be by means of input

power or gain reduction and not by an attenuating at the output of the device.