Table of Contents
Advertisement
INPUT CONNECTORS
DVI 1/ DVI A:
DVI-I input signal. Connect a DVI (digital) input signal and
select DVI 1 on the OSD monitor menu. Use a DVI to VGA adapter to
connect an ARGB (analogue) input signal and select DVI-A on the OSD
monitor menu.
DVI 2:
DVI-D input signal. Connect a DVI (digital) input signal and select
DVI 2 on the OSD monitor menu.
- Use high quality DVI cables with 2m maximum length.
12V D.C.:
Power supply input connector. XLR-4 connector.
- 1,2: Ground
- 3,4: 12Vdc
GPI:
Monitor external contact close control. SubD9 female.
1 . GPI1 +
2. GPI1 –
3. GPI2 +
4. GPI2 –
5. GPI3 –
6. GPI3 +
7. N.C.
8. +12Vdc (600mA max.)
9. Ground:
- Use GPI1 (1:12Vdc, 2: Ground) to open the monitor
- Use GPI3 (6:12Vdc, 5: Ground) to close he monitor
Termination:
Activate (ON) the termination ONLY, on the last unit of the
RS422 bus.
AHnet:
RJ45 CAT5 connector for addressable RS422 control. There is a loop
through connector to use as signal RS422 output. Up to 30 monitors can be
connected on the same RS422 bus.
Service:
Used for firmware upgrade.
17
Advertisement
Table of Contents
