Table of Contents
Advertisement
Installing a Backguard (Continued)
5.
Fasten the backguard and the stainless steel trim piece in
place with the five (5) existing chrome plated screws.
6.
Secure the rear of the backguard to the back of the range
with the eight (8) existing hex screws.
Backguard
Backguard Installation
7.
On the 24 inch backguard: Secure the "C" channels on the
24 inch backguard to the brackets mounted on the range
chassis using eight (8) hex screws from the kit. Insert the
screws through the holes in the back side of the backguard.
Hex Screw,
8 Places
Securing the Support Brackets on 24 inch Backguard
Installation Instructions
Chrome Plated
Screw, 5 Places
Hex Screw,
8 Places
Removing the Oven Door
•
Do not attempt to disengage the hinge catches with the
door removed from the oven. The hinge springs could
release causing personal injury.
•
Do not lift or carry the oven door by the door handle.
NOTE: When installing a backguard, always install it before
sliding the range into place. See page 8.
To make the range easier to move, remove the door(s) to reduce
weight.
1.
Open the door to its fully opened position.
2.
Rotate the catch over the retaining arm on each hinge.
Catch
Retaining Arm
Releasing the Door Hinges
3.
Lift the oven door to about a 15° angle from the vertical
position.
4.
Hold the door with both hands just below the handle and pull
it away from the oven while continuing to lift.
Door Gripping Points
WARNING
Hide quick links:
Advertisement
Table of Contents
