Specification - Hitachi UC 10SL2 Handling Instructions Manual

English

SPECIFICATION

CHARGER
Charging time
Charging voltage
Weight
APPLICATION
For charging the HITACHI BATTERY BCL10 series.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's
receptacle.
When connecting the plug of the charger to a
receptacle, the pilot lamp will blink in red. (At 1-second
intervals).
Table 1
Before
charging
While
charging
Charging
complete
Pilot lamp
(red)
Overheat
standby
Charging
impossible
(2) Regarding the temperature of the rechargeable
battery.
The temperatures for rechargeable batteries are
as shown in the Table 2, and batteries that have
become hot should be cooled for a while before being
recharged.
Table 2
Temperatures at which the battery can be recharged
0°C — 50°C
(3) Regarding recharging time
Table 3 shows the recharging time required according
to the type of battery.
4
power cord to
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Blinks
Lights continuously
Lights
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Blinks
Lights for 1 second. Does not light for 0.5
seconds. (off for 0.5 seconds)
Blinks
Lights for 0.1 second. Does not light for 0.1
seconds. (off for 0.1 seconds)
Flickers
( ): cells
1.3 Ah (3)
1.5 Ah (3)
3.0 Ah (6)
10.8 V
0.35 kg
2. Insert the battery into the charger.
Firmly insert the battery into the charger till it contacts
the bottom of the charger as shown in Fig. 1.
3. Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the
the
pilot lamp will blink in red. (At 1-second intervals.)
(See Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
Table 3 Recharging time (approx. min.) at 20°C
Battery 1.3 Ah
Voltage (3 cells)
10.8 V 25 min.
NOTE: The recharging time may vary according to the
ambient temperature.
4. Disconnect the charger's power cord from the
receptacle.
5. Hold the charger fi rmly and pull out the battery.
NOTE
Be sure to pull out the battery from the charger after
use, and then keep it.
Approx. 25 minutes
Approx. 30 minutes
Approx. 60 minutes
Symbol mark
Battery overheated.
Unable to charge
(Charging will
commence when
battery cools).
Malfunction in the
battery or the charger.
Battery capacity (Li-ion)
1.5 Ah
(3 cells)
30 min.
3.0 Ah
(6 cells)
60 min.