CYBEX Eagle NX Pulldown Owner's Manual page 17

7. Install ten screws securing top covers (front and back) to frame using a Phillips screwdriver.
Securely anchor machine to floor
Owner should not allow equipment to be used until it is properly anchored as described below.
Verify proper operation
Anchoring equipment:
• To maximize stability and eliminate rocking, tipping, or falling over, equipment
must be anchored to a solid, level surface, utilizing all anchoring holes provided.
• Fasteners must have a minimum of 500 lbs. tensile capacity. Cybex recommends
.3/8" grade 2 bolts or better. A minimum pull force of 220 lbs/100 kgs is required
for each anchor position.
• If leg frames do not contact surface, DO NOT pull down with anchors. Shim any
leg or frame not in contact with surface using flat washers.
• Due to the wide variation of flooring on which machines may be anchored or
installed, consult with a qualified and licensed contractor to ensure proper
anchoring and installation.
Page 17 of 25
Description
1 10-32 screw
2 # 8 screw
3 Top cover
4 Back panel
Qty
8
2
2
1