Stainless Steel Frame/Control Panel; Control Knob(S); Stainless Steel Surfaces - Miele ProLine CS 1013-1 Operating And Installation Instructions

Stainless steel frame/control
panel
 Clean the frame and the control panel
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
You can also use a ceramic and
stainless steel cleaning agent. We
recommend using a stainless steel
conditioning agent to help prevent
resoiling (see "Optional accessories").
Do not use a ceramic and stainless
steel cleaner or stainless steel
conditioning agent on the printing.
This would rub the printing off.
These areas should only be cleaned
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.

Control knob(s)

 Clean the control knob(s) using a
solution of warm water and a little
washing-up liquid applied with a soft
sponge. Stubborn soiling should be
soaked first.
 Dry the control knob(s) with a clean
cloth.
Cleaning and care

Stainless steel surfaces


Risk of damage by pointed
objects.
The seal between the cooktop and
the worktop could be damaged.
Do not use pointed objects for
cleaning.

Damage caused by soiling.
Soiling, particularly salty food or
liquid and olive oil, can cause
damage if left on the printed surfaces
for a long time.
Remove such soiling immediately.

Damage caused by incorrect
cleaning.
Stainless steel cleaning agents rub
off the printed symbols.
Do not use stainless steel cleaning
agents on printed symbols.
 Clean stainless steel surfaces using a
solution of warm water and a little
dishwashing liquid applied with a soft
sponge. Stubborn soiling should be
soaked first. If necessary, the rough
side of a non-scouring sponge can
be used.
 Finally, dry with a clean soft cloth.
27