Diagnostics; Arming Diagnostics; Disarming Diagnostics - DEI 7000 ESP Owner's Manual

Vehicle security system

Table of Contents

Diagnostics

The microprocessor at the heart of your system is constantly mon-

itoring all of the switches and sensors connected to it. It detects

any faulty switches and sensors and prevents them from disabling

the entire system. The microprocessor will also record and report

any triggers that occurred during your absence.

If the system is armed while an input is active (door open, sensor

triggering, etc.) the unit will chirp once when arming and then

again a few seconds later. This is called Bypass Notification. The

system will ignore the active input until it ceases. Three seconds

later it will monitor that input normally. For example, if your car

has interior light exit delay, and you arm the system before the

interior light goes out, you may receive Bypass Notification. Once

the light goes out, however, the doors are monitored normally.

NOTE: Bypass notification will not occur when using Silent Mode

chirps have been programmed OFF.

Extra disarm chirps indicate Tamper Alert. If four chirps are heard

when disarming, the system was triggered in your absence. If five

chirps are heard, a zone was triggered so many times that Nuisance

Prevention Circuitry

™

status LED will indicate which zone was involved (see Table of

2001 Directed Electronics, Inc.

has bypassed that zone. In either case, the

™

or if

Table of Contents