ElectrIQ EAH2000W User Manual page 4

restrict airflow, as this may present a fire risk.
 The heater must not be located immediately below a socket outlet.
 Always ensure the unit is secure before operation. Do not use on unstable or
uneven surfaces and if wall-mounted, it must be securely attached to a suitable
wall.
 Do not move or tilt the unit.
 Avoid keeping the unit in direct sunlight for a long period of time.
 The heater is designed to be used at temperatures above -20°C.
exposed to temperatures below this, it must be allowed to warm above this level
before operation.
 Do not attempt to repair, disassemble or modify the appliance.
contains no user-serviceable parts.
 Always unplug or disconnect the appliance from the mains power supply when
not in use, or when moving or cleaning it. Do not pull the cord to unplug the
heater.
 Keep the heater clean.
exhaust opening as this may cause electric shock, fire, or damage to the heater.
 Do not use the appliance for anything other than its intended use. It is designed
for domestic indoor use only.
 There may be a trace of odour during the first few minutes of initial use, or after
a period of storage. This is normal and will quickly disappear.
 This appliance has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint, or any flammable liquids are used or stored.
 Never locate this appliance where it may fall into a bathtub or otherwise become
exposed to water.
 This appliance is IP24 rated, and so can be used or installed within a bathroom
as long as the appliance and its cables are not within Zones 0-2.
 If used within a bathroom, the circuit must be protected by a suitable RCD to
prevent electric shock.
 Do not allow the appliance to be submerged or sprayed with water.
 If the unit is wall-mounted, it must be installed in accordance with current
regulations for the area of installation. If unsure, professional advice should be
sought.
 WARNING: To reduce the risk of fire or electrical shock, DO NOT use this
appliance with any solid-state Speed Control Device or any variable speed
controllers.
ENERGY SAVING AND UNIT SAFETY PROTECTION TIPS
 Do not cover or restrict the airflow. Do not use in a dusty environment.
 For safety and maximum performance, when the castors are fitted the
minimum distance from a wall or objects should be 50cm.
Do not allow any object to enter the ventilation or
Page 4 of 24
If it is
This unit