Multiple Event Total Recall; Diagnostics; Arming Diagnostics - Directed Electronics Concept 650 Owner's Manual

multiple event total recall

This will report the last eight system triggers in reverse chronological order.
1. Press and hold
2. While still holding
release the button.
3. The LED will start to flash to indicate the most recent trigger
and proceed down to the eighth trigger. If fewer than eight
triggers are stored in memory, the LED will flash continuous-
ly until the system is armed/disarmed using the transmitter
or the ignition is turned on. For more information, please
refer to the Table of Zones section of this guide.

diagnostics

The microprocessor at the heart of your security system is constantly
monitoring all of the switches and sensors that are connected to it. It
detects any faulty switches and sensors and prevents them from dis-
abling the entire system. The microprocessor will also record and report
any triggers that occurred during your absence.

arming diagnostics

If the system is armed while an input is active (door open, sensor trig-
gering, etc.) the unit will chirp twice when arming and then four more
times five seconds later. This is called Bypass Notification.
16
of the PlainView 2 Valet switch.
, arm and disarm the system, then