Table of Contents
Advertisement
PIN Code Confirmation Procedure
Begin this procedure within 15 seconds of finishing the programming
sequence or the new code will not be set.
1.
Turn on the ignition.
2.
Enter the new PIN code.
3.
Press and hold
LED turns on: New PIN code is learned and program-
ming is complete.
LED stays off: New PIN code is not learned and the sys-
tem reverts to the old PIN code. Redo the programming
sequence.
ultrasecure auto-immobiliser
The built-in dual circuit immobiliser autoimmobilises (arms automatical-
ly), 30 seconds after the ignition has been turned off. (This feature is a
Thatcham and EC requirement and, therefore is not programmable.)
auto-immobilisation sequence
1.
Turn ignition off or disarm alarm
2.
After 30 seconds the systems Immobilisation circuits activate
and engage the starter and ignition interrupt
3.
LED flashes at ½ normal speed
30
for three seconds.
Advertisement
Table of Contents
