Thermon Terminator DP Installation Procedures

Power connection kit for power connection, in-line splice connection, t-splice connection, or end termination applications

Terminator

Power Connection Kit for Power Connection,

In-Line Splice Connection, T-Splice Connection,

or End Termination Applications

Table of Contents

Need help?

Do you have a question about the Terminator DP and is the answer not in the manual?

Page 1 Terminator Power Connection Kit for Power Connection, In-Line Splice Connection, T-Splice Connection, or End Termination Applications INSTALLATION PROCEDURES...
Page 2 Support Cap with O-Ring • Component approvals and performance ratings are based on Threaded Grommet Compressor the use of Thermon specified parts only. User supplied power Grommet connection fittings must be listed or certified for intended use. Support Base with O-Ring •...
Page 3 INSTALLATION PROCEDURES For one, two or three cables. Locate bus Two cables. Three cables. connection (HPT and FP only) and cable as shown. Cut end of cable at angle to aid in piercing grommet. Leave additional cable for expansion loop. For one, two or three cables.
Page 4 Terminator DP Cut off end of cable. Terminate cable with appropriate PETK Push excess cable back through expediter. termination kit. Refer to PETK installation Tighten cap securely. Tape cable expansion loop instructions. to pipe. For power connection applications: Use Mount junction box base on expediter. Make...
Page 5 Thermon • 100 Thermon Dr • PO Box 609 San Marcos, TX 78667-0609 • Phone: 512-396-5801 • 1-800-820-4328 For the Thermon office nearest you visit us at . . . www.thermon.com Form No. PN50840-0519...