Related Manuals for Thermon TraceNet ECM-P/FAK-1
Summary of Contents for Thermon TraceNet ECM-P/FAK-1
- Page 1 TraceNet ECM-P/FAK-1 ECM—Electronic Control Module Mounted on FAK-1 Bulkhead Entry For Use With TubeTrace® Bundles INSTALLATION PROCEDURES...
- Page 2 PETK Power and End Termination Kits (per cable) Entry Kit with the ECM Electronic Controller. For translations other than English and local language translation provided here, please PETK-1 for RSX, VSX-HT, BSX contact Thermon. The English language installation procedure PETK-2 for KSX, HTSX shall govern. PETK-3-ECM...
- Page 3 • Component approvals and performance ratings are based on International Electrotechnical Commission IEC Certification Scheme for Explosive Atmospheres the use of Thermon specified parts only. User supplied power SIR 12.0103X connection fittings must be listed or certified for intended use.
- Page 4 TraceNet ECM/FAK-1 Mount Screw and Washers Cut and Remove to fit Expediter Base Heat Reflective Tape O-Ring Tubing Field Drilled (By Others) Heat Tracing FAK-1 Base Glass Fiber Tape Heat Tracing Weep Hole Tubing Bundle Complete with 1 additional pass of heat Mount expediter base with o-ring to FAK-1 base Cut FAK-1 top and base ends to match outside reflective tape.
- Page 5 30° for tight seal. To remove lid, repeat step 21 in opposite direction. Thermon • 100 Thermon Dr • PO Box 609 San Marcos, TX 78667-0609 • Phone: 512-396-5801 • 1-800-820-4328 For the Thermon office nearest you visit us at . . . www.thermon.com Form PN50073-1218 ©...
Need help?
Do you have a question about the TraceNet ECM-P/FAK-1 and is the answer not in the manual?
Questions and answers