Table of Contents
Advertisement
Operator Manual
If noise or uneven motion occurs when the table top is moving up or down, extend
and clean the lifting tube with a soft clean cloth.
CLEANING THE OPTIONAL RADIATION SHIELD
After each procedure, the radiation shield should be carefully cleaned.
CLEANING STEPS
Remove the panel sections and lay flat before using the recommended
1)
cleaner in an adequately ventilated area.
Apply to one side at a time and allow to stand a few minutes.
2)
Scrub with a soft bristle scrub brush. Do not let the solution dry before
3)
rinsing.
Rinse with water and a damp cloth.
4)
Scrub and rinse again, if necessary.
5)
Remove the main section of the radiation shield and clean in the same
6)
manner.
Place main section of shield back on tabletop.
7)
Install individual panel sections.
8)
APPROVED AND TESTED DISINFECTANT CLEANER:
• Scrubbles
www.infab.org/catalog/apron_options_and_accessories.htm
L100-3063 REV A
Aspect 100T
Avoid cleaning or getting cleaning solutions on
elevating tube if possible.
Observe cleaning product cautions found
on product labels.
(Infab Corporation)
www.imagediagnostics.com
CAUTION
CAUTION
23
Advertisement
Table of Contents
