Table of Contents
Advertisement
Operator Manual
ELECTRIC SYSTEM
CONTROL BOX
FUSE
AC POWER
110V 60Hz OR 230V 50Hz
(CHECK INPUT ON LABEL)
BATTERY FUNCTION (Motorized tables)
When AC power is applied, the battery will begin charging until the battery reaches full
capacity. When it does, the charging will taper off. If the power goes out, the table will
automatically switch to battery back-up mode.
Note: The battery will not charge if the emergency stop switch is pushed down.
An audible tone is sounded when using an operator control function if the battery
charge is low.
Local procedures may be in place for proper disposal or recycling.
For more information about batteries, such as battery life, production
codes and disposal go to the Linak web site for disposal information.
Select "Products|User Manuals" and click on "Actuators & Electronics".
Linak documentation can be found at their web site:
L100-3063 REV A
Aspect 100T
LIFT
ACTUATOR
TREND
ACTUATOR
B
A
5
4
3
2
1
F
SAFE DC VOLTAGES
CONTROLLER CONNECTIONS
PORT
DEVICE
1
TREND ACTUATOR
2
LIFT ACTUATOR
3
OPERATOR CONTROL
A
C
BAT
www.imagediagnostics.com
CONTROL
HAND CONTROL
COVER
(SEE BELOW)
EMERGENCY
STOP SWITCH
HAND OR
FOOT CONTROL
"ON" INDICATOR
www.linak.com
OR OPTIONAL
ELEVATE
FOOT CONTROL
ANGLE
CONTROL COVER
(CONTROL BOX INSIDE)
21
Advertisement
Table of Contents
