Table of Contents
Advertisement
Item
Check Oil Level
Check Coolant Level
Check Fuel Level
Check Tire Pressure
Check All Electrical Connections
Inspect Radiator Fins For Debris, Clean As
Required
Inspect Light Tower Winch For Proper Operation
Check Fuel Pipes And Clamp Bands
Clean Air Cleaner Element
Clean Fuel Filter
Check Fan Belt Tightness
Drain Water Separator
Check Radiator Hoses And Clamp Bands
Check Intake Air Line
Replace Fuel Filter Cartridge
Clean Water Separator
Lubricate Leveling Jacks
Remove Sediment In Fuel Tank
Replace Fan Belt
Replace Engine Oil And Oil Filter
Replace Air Filter Element
*
Change the engine oil and oil filter after the initial 50 hours of operation, then at the appropriate interval thereafter.
**
Replace the air cleaner element yearly, or after six cleanings, whichever occurs first.
Winch Use, Operation and
Maintenance—Manual
Prior to Use
•
Inspect cable and replace if damaged.
•
Check mounting hardware for proper tightness and
re-torque if necessary.
•
Gears, ratchet pivot point and shaft bushings must
be kept lubricated with a thin film of oil or grease.
Operation
Raising the Lights:
The cable must be securely fastened to the winch
1.
drum.
Verify the cable and cable attachments are not
2.
damaged. Verify there is adequate safety factor of
at least three times the maximum load for all
components
used.
Products
to
order
necessary.
Owner's Manual for MLT Light Tower
Table 4-2. Basic Maintenance Guide (Kubota)
Daily
Contact
Generac
Mobile
a
replacement
cable
50
100
200
Hours
Hours
Hours
Referring to the "Cable In / Cable Out" decal on the
3.
winch, turn handle according to the specified
direction to lift. The ratchet MUST make a loud
clicking sound while winding the cable.
Lowering the Lights:
Referring to the "Cable In / Cable Out" decal on the
winch, turn handle according to the specified direction to
lower. No clicking will be heard because the brake
system is activated.
Maintenance
The following procedures should be performed at least
annually:
See
Figure
4-1.The gears and bushings of the winch
1.
must be kept lubricated. Apply a thin film of grease
to the gear teeth (B), and oil the bushings as
needed (C).
The ratchet pawl pivot point must be kept
2.
lubricated with a thin oil.
if
NOTE: Do not get oil or grease on the friction discs (A).
Maintenance
400
500
1000
Hours
Hours
Hours
1
Year
*
**
25
Advertisement
Table of Contents
Troubleshooting
