Battery Hazards; Fuel Hazards; Engine Safety; Operating Safety - Generac Power Systems MLT4060M Owner's Manual

Introduction and Safety

Battery Hazards

DANGER
Electrocution. Do not wear jewelry while
working on this equipment. Doing so will
result in death or serious injury.
WARNING
Explosion. Batteries emit explosive gases while charging.
Keep fire and spark away. Wear protective gear when
working with batteries. Failure to do so could result in
death or serious injury.
WARNING
Explosion. Do not dispose of batteries in a fire. Batteries
are explosive. Electrolyte solution can cause burns and
blindness. If electrolyte contacts skin or eyes, flush with water
and seek immediate medical attention.
WARNING
Risk of burn. Do not open or mutilate batteries.
Batteries contain electrolyte solution which can
cause burns and blindness. If electrolyte contacts
skin or eyes, flush with water and seek immediate
medical attention.
WARNING
Environmental Hazard. Always recycle batteries at an
official recycling center in accordance with all local
laws and regulations. Failure to do so could result in
environmental damage, death or serious injury.

Fuel Hazards

DANGER
Explosion and fire. Fuel and vapors are extremely
flammable and explosive. No leakage of fuel is
permitted. Keep fire and spark away. Failure to do
so will result in death or serious injury.
DANGER
Risk of fire. Allow fuel spills to completely dry
before starting engine. Failure to do so will
result in death or serious injury.
•
DO NOT fill fuel tank near an open flame, while
smoking, or while engine is running. DO NOT fill
tank in an enclosed area with poor ventilation.
4
•
DO NOT operate with the fuel tank cap loose or
missing.

Engine Safety

Internal combustion engines present special hazards
during operation and fueling. Failure to follow the safety
(000188)
guidelines described below could result in severe injury or
death. Read and follow all safety alerts described in the
engine operator's manual. A copy of this manual was
supplied with the unit when it was shipped from the factory.
•
DO NOT run engine indoors or in an area with poor
ventilation. Make sure engine exhaust cannot seep
into closed rooms or ventilation equipment.
(000137a)
•
DO NOT clean air filter with gasoline or other types
of low flash point solvents.
•
DO NOT operate the unit without a functional
exhaust system.
•
Shut the engine down if any of the following
conditions exist during operation:
(000162)
• Noticeable change in engine speed.
• Loss of electrical output.
• Equipment connected to the unit overheats.
• Sparking occurs.
• Engine misfires or there is excessive engine/
generator vibration.
(000163a)
• Protective covers are loose or missing.
• Ambient air temperature is above 120°F (49°C).

Operating Safety

Positioning the Unit

(000228)
High Voltage. Verify area above unit is clear
of overhead wires and obstructions. Contact
with high-voltage power lines will result in
death or serious injury.
(000192) Burn hazard. Never operate lights with a
damaged or missing lens cover. Lamps are
hot and pressurized while in use. Unprotected
lamps can shatter, causing severe injury.
•
The area immediately surrounding the unit should
be dry, clean, and free of debris.
(000174)
•
Position and operate the unit on a firm, level
surface.
•
If the unit is equipped with a frame grounding stud,
follow National Electrical Code (NEC), state, and
local regulations when connecting.
DANGER
(000260a)
WARNING
(000277)
Owner's Manual for MLT Light Tower